 |
 |
| MBD-X8DAH+ -O |
- X8DAH+ (Standard Retail Pack)
|
| MBD-X8DAH+ -B |
|
| |
|
| Form Factor |
|
| Dimensions |
- 13.68" x 13" (34.7cm x 33cm)
|
| |
|
| CPU |
- Dual 1366-pin LGA Sockets
- Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Quad-Core Intel®
Xeon®Processor 5500
sequence (Nehalem-EP processor)
|
| QPI |
|
| |
|
| Memory Capacity |
- 18x 240-pin DIMM sockets
- Supports up to 144 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
- Supports up to 24 GB 1333 / 1066 / 800MHz DDR3 ECC Unbuffered memory
- Memory Mirroring supported
|
| Memory Type |
- 1333 / 1066 / 800MHz ECC Registered / ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
|
| Memory Voltage |
|
| Error Detection |
- Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
|
| |
|
| Chipset |
- Intel® 5520 (Tylersburg) chipset
- ICH10R +2x IOH-36D
|
| SATA |
- Intel ICH10R SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support
|
| IPMI |
- Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Winbond® WPCM450 BMC
|
| Network Controllers |
- Intel® 82576 Dual-Port Gigabit Ethernet Controller
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- Intel® I/OAT 3 support for fast, scaleable, and reliable networking
- VMDq support for better performance of virtualization
- 1x Realtek RTL8201N PHY (dedicated IPMI)
|
| Audio |
- Realtek ALC888 7.1 HD audio
|
| Super I/O |
|
| |
|
| Serial ATA |
- Six Serial ATA ports
- Six SATA hard drives supported
|
| IDE |
- Single EIDE channel supports up to two UDMA IDE devices (IDE-M, IDE-S) including CF(Compact Flash) Card
- Supports UDMA Mode 5, PIO Mode 4, and ATA/100
|
| Floppy |
- 1 Floppy controller; 1.44 MB
|
| LAN |
|
| USB |
- 6x USB rear ports
- 1x USB on-board
- 2x USB internal headers (3 ports)
- Total 10 USB 2.0 Compliant
|
| Audio |
- Realtek ALC888 7.1 HD audio
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Port / Header |
- 1 Fast UART 16550 serial port
- 1 Fast UART 16550 serial header (Option)
|
| IEEE 1394a |
- 2x IEEE 1394a ports (1x header)
|
|
|
|
|
| 2U Chassis |
- CSE-213A-R900LP
- CSE-216A-R900LP
- CSE-216E1-R900LP
- CSE-216E2-R900LP
- CSE-823MTQ-R700LP
- CSE-825MTQ-R700LPB
- CSE-825TQ-560LPV
- CSE-825TQ-R700LPV
- CSE-826TQ-R800LPV
|
| 3U Chassis |
- CSE-835TQ-R800B
- CSE-836E1-R800V
- CSE-836E2-R800V
- CSE-836TQ-R800V
- CSE-936A-R900B
|
| Tower / 4U Rackmount |
- CSE-745TQ-800
- CSE-745TQ-R800
- CSE-846E1-R900B
|
| Important Chassis Notes |
- To ensure system stability, a 550W (minimum) ATX power supply
[Two 8-pin (+12V) and 24-pin are required]
|
| |
|
| PCI-Express |
- 2 (x16) PCI-E 2.0 slots
- 4 (x8) PCI-E 2.0 slots (1 in x16 slot)
- 1 (x4) PCI-E slot
|
| |
|
| BIOS Type |
- 32Mb SPI Flash EEPROM with AMI® BIOS
|
| BIOS Features |
- Plug and Play (PnP)
- PCI 2.2
- ACPI up to 3.0
- USB Keyboard support
|
| |
|
| Software |
- IPMI (Intelligent Platform Management Interface) v1.5 / 2.0 with KVM support
- Super Doctor III
|
| Power Configurations |
- ACPI / ACPM Power Management
|
| |
|
| CPU |
- Monitors for CPU Cores, +1.8V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, Memory, Chipset Voltages.
- 6-Phase-switching voltage regulator
|
| FAN |
- Total of eight fan headers supporting up to 8 fans
- Eight 4-pin fan headers
- 8x fans with tachometer status monitoring
- Support 3-pin fans (w/o speed control)
- Low noise fan speed control (4-pin fan only)
|
| Temperature |
- Monitoring for CPU and chassis environment
- Thermal Control for 8x fan connectors
- PECI
|
| Other Features |
- Chassis intrusion detection
- Chassis intrusion header
|
| |
|
RoHS
|
- RoHS Compliant 6/6, Pb Free
|
| Environmental Spec. |
- Operating Temperature: 10° to 35° C (50° to 95°F)
- Non-operating Temperature: -40° to 70° C (-40° to 158° F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|
Xeon Boards 
