 |
 |
| SYS-1016T-M3FB |
- SuperServer
1016T-M3FB (Black)
|
| |
 |
| CPU |
- Dual 1366-pin LGA Sockets
- Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Quad-Core Intel®
Xeon®Processor 5500
sequence (Nehalem-EP processor)
- NOTE: Support processors with Max TDP < 100W
|
| QPI |
|
| |
 |
| Memory Capacity |
- Supports up to 24 GB 1333 / 1066 / 800MHz DDR3 ECC / non-ECC Un-Buffered memory
- Three Channel memory bus
- 6 DIMM sockets
|
| Memory Type |
- 1333 / 1066 / 800MHz Un- Buffered ECC / non-ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
- 256MB, 512MB, 1GB, 2GB, 4GB
|
| Memory Voltage |
|
| Error Detection |
- Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
|
| |
 |
| Chipset |
- Intel® X58 Express chipset
- ICH10R
|
| SAS |
-
LSI SAS1068E
o RAID 0, 1, 10 support
- (Optional: AOC-IButton68) RAID 5 support
|
| SATA |
- Intel ICH10R SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support
|
| IPMI |
- Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Winbond® WPCM450 BMC
|
| Network Controllers |
- 2x Intel® Gigabit Ethernet Controllers
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8201N PHY (dedicated IPMI)
|
| Graphics |
|
| Super I/O |
|
| |
 |
| SAS |
|
| Serial ATA |
- Six Serial ATA ports
- Six SATA hard drives supported
|
| Floppy |
- 1 Floppy controller; 1.44 MB
|
| LAN |
|
| USB |
- 4x USB rear ports
- 2x USB on-board
- 4x USB internal headers
- Total 8 USB 2.0 Compliant
|
| VGA |
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Port / Header |
- 1 Fast UART 16550 serial port
- 1 Fast UART 16550 serial header (Option)
|
|
 |
 |
 |
| Form Factor |
|
| Model |
|
| |
 |
| Height |
|
| Width |
|
| Depth |
|
| Gross Weight |
|
| Available Colors |
|
| |
 |
| Buttons |
- Power On/Off Button
- System Reset Button
|
| LEDs |
- Power LED
- Hard drive activity LED
- 2x Network activity LEDs
|
| |
 |
| PCI-Express |
- 1 (x16) PCI-e 2.0 slot via riser card
|
| |
 |
| Hot-swap |
- 8x 2.5" Hot-swap SAS / SATA drive bays
|
| |
 |
| 1x SAS / SATA Backplane |
| |
 |
| Fans |
- 4x 40x28mm high-efficiency fans
- 6x fans maximum
|
| |
 |
| 560W AC to DC power supply w/ PFC |
| AC Voltage |
- 100-240 V, 50-60 Hz, 6.5-2.6 Amp
|
| +5V |
|
| +12V |
|
| |
 |
| BIOS Type |
- 4Mb SPI Flash EEPROM with AMI BIOS
|
| BIOS Features |
- DMI 2.3
- PCI 2.2
- ACPI 1.0 / 2.0
- USB Keyboard support
- SMBIOS 2.3
|
| |
 |
RoHS
|
|
| Environmental Spec. |
- Operating Temperature: 10° to 35°C (50° to 95°F)
- Non-operating Temperature: -40° to 70°C (-40° to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|